CARING FOR YOUR VISION 180 TRIMMER

OILING BLADES

For best results, put one or two drops of Wahl Clipper Oil on the blades only when necessary, or approximately once a month. Motor bearings are permanently lubricated - do not attempt to oil.

When oiling your trimmer, turn the trimmer "1" ON, hold the unit with the blades facing DOWN and squeeze one or two drops of oil onto the blades. Wipe off excess oil with soft cloth.

NOTICE - DO NOT OVER OIL!

Excessive oiling or application of liquids will cause damage if allowed to seep back into motor.

BLADE CARE

Trimmer blades have precision-hardened, ground and lapped cutting teeth. Blades should be handled carefully and never bumped or used to cut dirty or abrasive material.

Should blades become damaged or dull, you may purchase a new blade assembly from Wahl. Be sure to ask for the Vision 180 blade assembly.

CLEANING / STORAGE

Before storing your trimmer, use the cleaning brush to whisk any loose hairs from the unit and the blades.

For more thorough cleaning of the trimmer blades:
Be certain the trimmer is in the "O" OFF position.

Remove trimming guide/blade guard.

Holding the trimmer in one hand, use the thumb of the other hand to push the blades away from the front of the trimmer. The blade assembly will pivot away in one piece.

Lightly brush hair from blade assembly and compartment.

Pivot blades back up and snap them into position. If blade assembly detaches from unit, reattach it to the trimmer by placing one side of the assembly into the pocket on the bottom of the housing and pushing the other side into place. Then pivot blades back up and snap into position.

When the trimmer is not in use, the trimmer guide/blade guard attachment should be in place to protect the blades.
Store trimmer in a manner that protects the blades from damage. Keep the cord untwisted and unobstructed. When stored, the cord should be coiled and the unit placed in a dry place, away from children.